Instructions
ol
liWhile using this product please pay attention to distinguish thereare two air pipe joints American and French Its own joint is American the French one can be used when it screwed on the American joint Connect one end of the tire inflation joint with the air cylinder and tighten the other end on the tire valve Please note that the CONNECTION SEQUENCE is very importantli
liAfter the inflation is doneunscrewthe joint quickly from the valve and PLEASE note whether the connector is HOT Its normal if there have a little air leakage when unscrewing the connector If the tire pressure is too high please releasetireair by turn the inflation joint to a appropriate place on the valveli
liUnscrewing the inflation joint from the main machine pack the cylinder away and place it in a dry ventilated and safe placeli
ol
nbsp
strongButton Operationstrong
nbsp
ol
liPowerOn button Press and hold for 3s to turn it on and press for 3s to enter sleep state and shut it downli
liSetting button Short press to switch the air pressure unit PSI BAR KAP KGCM? Press and hold for 3s to turn on the LED lightingli
ol
3button Short press to add oncepress and keepadding
4button Short press to decrease oncepress andkeep decreasing
5USB reverse charging mode Thepumpmust be turned off when charging and after plugging in the USB cable pressany ofa button for 3 seconds to enter the charging mode and it will automatically disconnect when it is fully charged
6Pressand holdthe poweronbutton after power onpress the setting button to select the unit PSI BAR KAP KGCM? and then press the plusortoadjustmentthe air pressure value Whenadjustingthe value it will flash and after the flash stops press the poweronbutton to startinflating When the inflation pressure reaches the pressure value you set the smart inflatorwill automatically stop the inflation work immediately
nbsp
strongTechnicalParametersstrong
Car power input12V 3A
Input voltage charger5V2A
Working current15A
Maximum current5A
Noload current2A
Air efficiency charge 195Bar mountain tires for 2 minutes
Emergency lighting 80 bright current for 10 hours
Operating temperature2070
Charging methodMicro USB
Charging time about 4 hours
Chargingpressure150PSI103BAR990KPA105KGCM
Product Size2606048mm
Product Weight460g
nbsp
Precautions
Dont place it in where children can reachNever insert the trachea into the mouth ears and eyes of people or animals to inflate andDO NOTuse the pump as a toy
Its forbidden to use this machine near flammable and explosive liquids and gases such as gas stations
Dont walk away while inflating After 8 minutes of continuous use the machine must be stopped for 8 minutes
If there is abnormal noise or the temperature is too high during inflation please shut down immediately and allow it to cool down for at least 15 minutes When disassembling the trachea please note it is HOT
If this machine will be out of using for a long time please must store it in a dry and closed place For longterm storage it is recommended to charge it once every three months
Before using the rechargeable pump check whether it has been charged enough The first charge requires more than 4 hours to be fully charged After that each charge should be fully charged and the charging indicator lights up in green means full charge
The inflatable cylinders are separately equipped with batteries that can be used for wireless inflating
Models without batteries need to be connected to the car charging source and cannot be used wireless
Warning
For the safety of you and others please use the pump and its accessories in accordance with the instructions provided by the manufacturer
Use methods not mentioned in the manual may cause danger
nbsp