MINI soldering station Digital electronic welding iron DC Version Portable without power supply

The melting point is the melting point of the substance itself When the temperature of the substance reaches the melting point of the substance it is possible that the substance cannot be melted For example the melting point and freezing point of ice are both 0 degrees Celsius and water does not necessarily freeze at 0 degrees Celsius Since the temperature of the substance is affected by the surrounding environment the actual melting point of the tin wire is higher than the melting point indicated by the tin wire If the wire is placed in a thermostat tin furnace at 226 degrees Celsius it is possible to melt in a sealed tin furnace If it is wrapped around the soldering iron tip it is impossible to melt Because there is a gap between the tin wires and the soldering station has a temperature difference the soldering iron will lose some heat when it heats up and the surrounding air will also absorb heat The melting point of normal wire is 227 degrees Celsius and the room temperature is low in winter Under the premise of calibrating the temperature of the soldering station at least 50 degrees Celsius should be increased to offset the heat absorbed by the air so that the heat of the wire itself can be increased to 228 degrees Celsius

About the wake of the handle

Please carefully understand the working principle of the vibration switch in the handle The ball trigger switch built in the handle the mounting direction of the ball switch and the rolling direction of the ball inside the ball switch need to vibrate the handle when the direction of the handle is consistent For example when the handle is vertical Please move the handle up and down When swinging the handle up and down please make sure that the ball inside the handle can trigger the SW wakeup mode and the force needs to be slightly larger When the handle is placed horizontally please swing the handle left and right Please swing the handle to an angle greater than 30 degrees so that the ball inside the handle can trigger the SW wakeup mode

About the soldering station showing of ERROR

If the ERROR is displayed the handle or the tip is not installed properly Please use a pair of pliers to push the tip into the innermost part of the handle Then try rotating the tip to ensure that the tab of the tip is in good connect with the inner tab of the handle If ERROR is still displayed and the light is always on when the tip or handle is installed please contact us to get a solution We encourage buyers to communicate with us to solve any problems We will do our best for each buyer