Wit House Wireless Universal RF433 Remote Controller

Operating instructions
1 Code clearing when closing the door at the same time press and hold the lock with the upper and lower keys some shells have two keys the LED indicator flashes three times press any key and the other one is not loose Press the release key three times and the LED flashes quickly to enter the state At this time all the memory data are cleared After the remote control data is cleared press any key and the LED indicator lights up
2 Copy one handheld original remote control and the other handheld copy remote control The two remote controls should be as close as possible ideally the two remote controls are side by side at zero distance on the desktop Press the required copy keys respectively and the LED indicator flashes quickly after flashing three times The copy is successful The operation methods of other keys are the same as above Some remote controls have low transmission power so they should be equipped with remote controls to copy the remote control operation backtoback to deal with it If there is interference in some operating environments interference with operation should be avoided If the copy is not good it should be copied again after the code is cleared
3 Recovery when accidentally clearing the password of the copy remote control you can press the two buttons at the bottom of the copy remote control at the same time The LED will flash quickly after flashing three times After releasing press any key again and the light will be on for a long time indicating that the password of the copied remote control has been restored Please be sure to clear the existing code of the copy remote control before using our copy remote control for copying
4 After copying how to control some keys and the rest cannot control LEDs you can use the prompt of cleaning and recovery operation The specific operations are as follows
1 Clear the code first
2 After the code clearing is successful copy the keys that have not been successfully copied again Do not copy the keys that have been successfully copied before
3 Clear the code again
4 Conduct a recovery operation At this time the key that is not successfully copied is overwritten by the new copy code while the original copy of the success code is retained If the key is not copied successfully after the second copy it can be recoded If the key is not copied successfully it can be copied again and then recoded and recovered Repeat until all keys are successfully copied This tip can be used to reduce the trouble of repeated operations

be careful
Due to manual measurement please allow a difference of 13mm
Due to different monitors and different lights the picture may not show the actual color of the commodity Thanks for your understanding
Packing list
1 x clone remote control