Car Paintless Dent Repair Tools Set Auto Sheet Metal Removal Kit Slide Hammer Reverse Hammer Automobile Maintenance Renovate Kit

span stylefontsize 16pxstrong43 Pcs Set strongspan
1x T Bar Tools
20x Short Blue Tabs5 Sizes
10x Glue stick 5 yellow and 5 black
4 x Long Blue Tabs 2 Sizes
2 x holder 2 Sizes
2x Shovel
1x Towel
1x Glue gun220V EU Plug 110V US Plug
1x Alcohol BottleAlcohol not included
1x The Instruction

strongspan stylefontsize 16px24 Pcs Setspanstrong
20x Short Blue Tabs5 Sizes
2x Shovel
1x Towel
1x T Bar Tools

strongspan stylefontsize 16px27 Pcs Setspanstrong
20x Short Blue Tabs5 Sizes
4 Long Blue Tabs 2 Sizes
2 holder 2 Sizes
1x T Bar Tools

strongspan stylefontsize 16px6 Pcs Setspanstrong
4 x Long Blue Tabs 2 Sizes
2 x holder 2 Sizes

strongDescriptionstrong
This Paintless Dent Repair TBar puller is a lightweight glue tab pulling tool meant to be used when repairing pressure dents and any dent that isnt sharp or creased
The tension puller works well with a tap down hammer when pulling large dents
Its very easy to control everyone can removal the dent easily by yourself

strongFeaturesstrong
1 Slide hammer is more powerful for dent repair conquer big dent
2 The principle is making glue tabs stick on the dent and use tools pulling the tabs and lift the dent
3 Big dent needs slide hammer or puller small dent needs mini dent lifter or pulling bridge
4 Different tabs for different dent lifter or the Slide hammer works with all glue pullers
5 Use a slide hammer or dent lifter or any pulling tools lift the dent try many times

strongHow to usestrong
1Clean the dent with a clean wet cloth
2Mount the glue stick into the glue gun pull the trigger to let the glue stick enter into the glue gun connect the power source and preheat for 5 minutes
3Use a proper drawing gasket Large dent requires a large drawing gasket
4 Pull the trigger and apply the drawing gasket with extruded glue
5 Fast place the drawing gasket with hot melt glue at the center of dent press lightly until the glue cures and adheres
6 Align the Tshaped repairer and press the drawing gasket with hot melt glue pull the sliding rod backwards to pull up the dent
7 Check with a Line board If dent still exists knock it slightly with a flattening hammer or pen
8 Clean the repaired place with a clean wet cloth